Interlux
Contact the store for delivery options (250) 334-2886
Pickup available at 2946 Kilpatrick Avenue
Usually ready in 24 hours
Tech Specs
Cetol® Marine Gloss with Next Wave™ UV-absorbing technology is a durable clear gloss protective wood finish, developed as a topcoat for Cetol Marine, Cetol Marine Light and Cetol Marine Natural Teak. Next Wave technology is the next generation of Cetol Marine from Sikkens with a unique UV-absorbing package, which is specialty resins and advanced UV absorbers that provide greater protection, durability and longevity. Cetol Marine Gloss provides a high gloss, hard wearing, UV protection and an easy to clean finish. It can be used where a gloss appearance is preferred on top of Cetol Marine, Cetol Marine Light and Cetol Marine Natural Teak. Do not use on decks..
Additional Information
Video
Instructions
BARE FIBERGLASSIn Good Condition Begin by scrubbing well using soap and water and a stiff brush. Rinse with fresh water and allowto dry. Wipe a small area with a clean rag that has been wetted with Fiberglass Solvent Wash 202. While the surface isstill wet wipe with a clean dry rag. Continue this process until the entire surface has been cleaned. Sand using 180-220 grade (grit) paper. Remove sanding residue.
MOLDED IN NON-SKID SURFACES Scrub with Fiberglass Surface Prep YMA601 or Solvent Wash 202V using a 3MDoodlebug™ and a maroon Scotch-Brite ® pad. Rinse with fresh water.
PREVIOUSLY PAINTED SURFACESIn Good Condition The surface must be clean and dry. Sand with 220-320 grade (grit) paper. Remove sandingresidue.In Poor Condition Remove all previous coatings and prime the substrate.
BARE WOOD Sand surface wipe clean. Apply Prekote Primer. Sand surface wipe clean.METAL Use Interprotect 2000E to prime the surface of the prepared metal. See the Interprotect 2000E TechnicalDatasheet for bare metal preparation guidelines.
CLEAR EPOXY Clean as for Bare Fiberglass above. Sand with 80 grade (grit) paper. Remove sanding residue. Applyone coat of Epoxy Barrier-Kote 404/414.Method Sand the primer with 180-220 grade wet or dry paper. Remove dust with a dust wipe.
Apply 1-2 coats.
Hints Mixing Stir well before use.
Thinner Brushing Liquid 333
Cleaner Special Thinner 216.Ventilation and Humidity Control Apply in dry well ventilated conditions.
Other
For best results either stipple by brush or use a mohair roller.
Some Important Points Product temperature should be minimum 10°C/50°F and maximum 35°C/95°F. Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F.Compatibility/Substrates Suitable for all substrates and filled surfaces. Not suitable for permanently immersed surfaces. Do not clean with highlyalkaline cleaners.Number of Coats 1-2Coverage (Theoretical) - 386.7 ft²/galRecommended DFT 2 mils dryRecommended WFT 3.7 mils wetApplication Methods Brush Roller